Replacing a Display in a Cumberland Kiosk

  • The purpose of this guide is to provide a walkthrough of the process of installing a new display in a Cumberland kiosk
  • This guide is intended for the personnel responsible for maintaining the kiosk
  • If you require any assistance past what this guide provides, please contact Versatile Credit Customer Support

Before You Begin

Before beginning the kiosk installation, be sure that you have the following:

  1. The key to open the kiosk
  2. A Phillips Head screwdriver

Step-by-Step Guide

  1. Open the kiosk and locate the four screws securing the display to the kiosk

    The back of a Cumberland display. The four screws that hold the display in place are secure and all cables are connected.

  2. Begin unscrewing the four screws, but don’t entirely remove them
  3. Lift the display and remove it from the kiosk, unplugging all cables that might be connected to the display

  4. Place the display on a flat surface

    A Cumberland display in its enclosure currently laying flat on a work surface.

  5. Unscrew the six screws securing the sides of the display enclosure and the four screws on the back of the display

    A side view of a Cumberland display. The screws that lock the enclosure are visible on the sides.

  6. Carefully open the display enclosure and remove the defective display
  7. Place the new display in the enclosure and secure all screws (do not fully tighten the four screws on the back of the screen)
  8. Connect all cables to the new display
  9. Place the display on the kiosk using the four screws on the back
  10. Secure the four screws
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.